方式一
步骤1:
配置sw1名称及逻辑(虚拟)IP地址
<Huawei>sys
[Huawei]sys sw1 \\改名为sw1
[sw1]int vlanif1 \\进入逻辑接口
[sw1-Vlanif1]ip add 192.168.12.1 24 \\添加IP
[sw1-Vlanif1]qu [sw1]qu <sw1>
配置sw2名称及逻辑(虚拟)IP地址
<Huawei>sys
[Huawei]sys sw2
[sw2]int vlanif1
[sw2-Vlanif1]ip add 192.168.12.2 24
[sw2-Vlanif1]qu [sw2]
步骤2:
配置sw2远程登录
[sw2]user-interface vty 0 4 \\设置同时登录用户数量
[sw2-ui-vty0-4]authentication-mode password
\\使用密码登录
[sw2-ui-vty0-4]set authentication password simple 123
\\设置密码为123(越是高端的交换机对密码的格式要求就越高,比如密码长度、不能包含用户名字段等等,注意有没有报错信息)
[sw2-ui-vty0-4]user privilege level 15
\\设置登录用户的操作权限15为最高
[sw2-ui-vty0-4]idle-timeout 3
\\用户3分钟无操作退出登录
步骤3:
在sw1登录sw2
<sw1>telnet 192.168.12.2
\\注意在用户视图下敲命令<sw1>
Trying 192.168.12.2 ...
Press CTRL+K to abort
Connected to 192.168.12.2 ...
Login authentication
Password:
Info: The max number of VTY users is 5, and the number
of current VTY users on line is 1.
The current login time is -10-11 13:37:16
<sw2>
方式二
步骤1:配置IP,修改名称(略)
步骤2:分别在sw1和sw2上配置以下代码
aaa local-user hf password cipher hf@123
local-user hf privilege level 15
local-user hf service-type telnet
qu
user-interface vty 0 4
authentication-mode aaa
protocol inbound telnet
交换机开启telnet命令:
另电脑终端也需开启telnet功能组件。
console加密:
[sw1]user-interface console 0 [sw1-ui-console0]authentication-mode aaa [sw1-ui-console0]qu [sw1]aaa [sw1-aaa]local-user admin1 password cipher hf@12345678 [sw1-aaa]local-user admin1 privilege level 15
原创不易,转载请注明出处:
【HCIA 02】华为交换机配置telnet远程登录_sxhuafeng的博客-CSDN博客_华为交换机telnet登陆