动态拉伸强度,dynamic tensile strength
1)dynamic tensile strength动态拉伸强度
1.A new experimental method was developed to measure thedynamic tensile strength of fragile tungsten alloys.针对易碎型钨合金具有高的动态压缩强度和低的动态拉伸强度这一特点 ,根据一维应力波理论设计一种测试易碎合金动态拉伸强度的实验方法 。
2.With finite element analysis,dynamic tensile strength for marble was obtained and typical failure modes of the Brazilian disc and the flattened Brazilian disc were analyzed.结果表明,大理岩的动态拉伸强度随着应变率的提高而增加。
3.An experimental procedure and accompanying method for analyzing recorded data for derivingdynamic tensile strength and elastic modulus of brittle material is presented.提出了获取脆性材料动态拉伸强度及弹性模量的实验步骤及相关记录数据的分析方法。
2)dry strength干态拉伸强度
3)hot tensile strength热态拉伸强度
4)tensile strength拉伸强度
1.Influence of microstructure on phase transformation andtensile strength of hot-rolled TN479 shape memory alloy rod;TN479形状记忆合金棒材显微组织对相转变和拉伸强度的影响
2.The assessment of measurement uncertainty in thetensile strength tests on metal specimen;金属试件拉伸强度试验测量不确定度的评定
3.Effect of fiber surface treatment ontensile strength of C/SiC composites;纤维表面处理对单向C/SiC复合材料拉伸强度的影响
英文短句/例句
1.determination of the apparent initial circumferential tensile strength表面内周拉伸强度的测
2.V-belts--Tensile strength and elongation test methodGB/T3686-1998V带拉伸强度和伸长率试验方法
3.Flat transmission belting--Test method of full thickness tensile strength and elongationGB/T6761-1986平带全厚度拉伸强度和伸长率测定方法
4.Research of the Preparation and Properties of the UPR Resin with High Tensile Strength and High Elongation at Break高拉伸强度高断裂伸长率UPR制备与性能研究
5.testing methods for tensile strength of adhesives胶粘剂拉伸强度试验方法
6.Tensile Strength of C/Al Composites at High Temprature碳(石墨)/铝复合材料的高温拉伸强度
7.With the chlorine content increasing, tensile strength and tear strength improved.随着氯含量的增加，拉伸强度、裂强度都增大。
8.The results of the tensile test indicate that the composite exhibit relatively high strength both at room temperature and high temperature.拉伸试验结果表明,该种复合材料具有较高的室温和高温拉伸强度。
9.A Prediction Approach to Tensile Strength of Fiber-reinforced Composites Using Weak-link Scaling纤维增强复合材料拉伸强度的weak-link比例预测
10.EVALUATION OF UNCERTAINTY IN MEASUREMENT OF PLASTICS TENSILE STRENGTH塑料拉伸强度测量结果的不确定度评定
11.Effect of Rejoin Length on Tensile Strength of GFRP Composites搭接长度对玻璃钢复合材料拉伸强度的影响
12.full thickness tensile strength and elongation for conveyor belts纺织品生产用输送带全厚度拉伸强度和伸长率测定方法
13.Vulcanized rubber--Determination of tensile strength and ultimate elongation at high temperaturesGB/T6037-1985硫化橡胶高温拉伸强度和扯断伸长率的测定
14." Polymeric materials, cellular flexible--Determination of tensile strength and elongation at break"GB/T6344-1996软质泡沫聚合物材料拉伸强度和断裂伸长率的测定
15.Conveyor belts of textile carcase--Test method for tensile strength and elongationGB/T3690-1994织物芯输送带拉伸强度和伸长率测定方法
16.In comparison to other leathers, deerskin offers comparatively high tensile strength.与其它皮革相比，鹿革有更高的拉伸强度。
17.The tensible strength of vagus and spinal nerves is very alike.迷走神经与脊神经的拉伸强度几乎完全相同。
18.testing method for tensile loss of textile to chlorine bleaching纺织品残留氯对拉伸强度变化的测定法
相关短句/例句
dry strength干态拉伸强度
3)hot tensile strength热态拉伸强度
4)tensile strength拉伸强度
1.Influence of microstructure on phase transformation andtensile strength of hot-rolled TN479 shape memory alloy rod;TN479形状记忆合金棒材显微组织对相转变和拉伸强度的影响
2.The assessment of measurement uncertainty in thetensile strength tests on metal specimen;金属试件拉伸强度试验测量不确定度的评定
3.Effect of fiber surface treatment ontensile strength of C/SiC composites;纤维表面处理对单向C/SiC复合材料拉伸强度的影响
5)tension strength拉伸强度
1.Study on the biaxialtension strength of pebble concrete and gravelly concrete;碎石混凝土与卵石混凝土双向拉伸强度研究
2.The experiment compare of carbon cloth stension strength with and without glue indicates that the epoxy resin can not only make the fiber adhesive united but also increase the tensile strength.对比有胶与无胶纤维布拉伸实验,表明环氧树脂不仅粘接纤维布,对纤维布有保护作用,而且能够显著提高其拉伸强度。
3.The change of thetension strength and the rupture elongating rate with different loading rates and ultraviolet radiation exposure time was measured and analyzed.研究了人工模拟紫外线照射条件下软包装复合材料(BOPET/AL/LDPE)拉伸性能的变化情况;分析了不同加载速率和紫外线照射时间下,复合材拉伸强度和伸长率的变化规律。
6)dynamic tension动态拉伸
1.Experimental studies ondynamic tension of metal ring by electromagnetic loading;实现金属环动态拉伸的电磁加载技术研究
2.The mechanisms of crack forming and propagation were investigated duringdynamic tension under static load by SEM.采用熔铸法制备的原位自生TiC/Ti复合材料,在SEM中静载动态拉伸,原位观察和研究了裂纹的萌生及扩展机制。
3.The dynamic tensile properties of tungsten fibers(80%,volume fraction) reinforced Zr based amorphous alloy matrix composite was investigated by means of the Split Hopkinson Pressure Bar(SHPB),and Scanning Election Microscope(SEM) was used to evaluate the fracture mode of the composite underdynamic tension.采用霍普金森杆拉伸技术研究了W丝体积分数为80%的W丝/Zr基非晶合金复合材料的动态拉伸性能,通过扫描电镜研究了该复合材料动态拉伸断裂模式。
延伸阅读
拉伸强度分子式：CAS号：性质：又称抗拉强度，抗张强度，扯断强度。符号σb。材料或构件受拉力时抵抗破坏的能力。可用强度极限来表示。金属和非金属材料的机械性能的一项指标。单位为Pa[帕(斯卡)]。纸张作纵向测定或横向测定，分别称纵向拉伸力或拉伸抗张力。
